It’s that time of year again. That time when you’ve designed this year’s Christmas card, and it’s time to make all 75 cards that are apparently required. So, a mass production line swings into action. Here are some tips:
- When heat embossing large numbers of images, consider getting a teppanyaki hot plate (top right). Cover with a heat resistant non-stick sheet, turn up to a temperature where the embossing powder just melts, and then as you stamp and add the powder to each piece, the previous piece is melting. Slide the piece off with the end of a paintbrush as the embossing powder finishes melting. Occasionally you may need to push the card to the hot surface (again with the end of a paintbrush) if it has curled up.
- Liquid Pearl dots love to cling and merge to the next one if wet. In my mass production line, I dotted in the same place on each holly sprig before leaving the set to dry. After a minimum of an hour, I did the next dot on each sprig, and left them again. Finally the third dot was added in the same fashion.
TOP TIP:
If your Liquid Pearls is misbehaving, warm it up on a radiator or in your pocket. It become less viscous, flowing better and forming nice domes. - Assemble in batches – and take a break between batches to stretch, change your attention, and generally improve productivity. And prevent boredom!
As to the finished result – you’ll have to wait and see. Especially if you’re one of the lucky 75 that receives the real thing 😉